BFT STOPPY B KIT 500mm electro-mechanical automatic rising bollard kit with control panel

BFT STOPPY B KIT 500mm electro-mechanical automatic rising bollard kit with control panel

Product ID: STOPPYB500KIT

Designed for domestic driveway installations to control access and provide security to property and buildings, the BFT Stoppy B 500 Kit is a simple, ready to install and value for money automatic rising bollard kit.

Electro-mechanical automatic rising bollard kits
Can be used with additional automatic rising bollards BFT STOPPY B 500mm electromechanical automatic rising bollard
230 V
Diameter: 115 mm
Raised Height 500 mm
Rear-reflecting strip
Impact resistance 6000 J

Options for controlling the barriers are:

The Mitto transmitter which can be programmed straight in using the built in receiver (sold separately)
Loop detectors for vehicles (sold separately)

£1,924.50

Become a Trade Customer

To receive our best prices on thousands of automation, access control and safety products.

Additional Information

Overview:

Guarantee: 2 years
Opening/closing time: 7 seconds
Usage: semi-intensive

Installation:

Requires a 230v power supply to each panel
Foundation depth Min 1200mm (including 125mm for drainage) x 800mm x 800mm to be concreted below ground with adequate drainage
High water areas may experience slow water drain-off
Not recommended for sites prone to regular flooding
PERSEO CBD Control panel: Maximum of 4 bollards in parallel on the same system
Distance between bollards should be 1-1.5 metres

Specification

Control unit	PERSEO CBE
Power supply	230 V
Power consumption	300 W
Opening or closing time	7 s
Rod height	500 mm
Rod diameter	115 mm
Type of limit switch	REED magnetic sensor
Slowdown	Yes

Impact resistance	6000 J
Break-in proof	60000 J
Manual cycle	reversible in the absence of voltage
Frequency of use	Semi intensive
Protection rating	IP67
Environmental conditions	-20 ÷ 60 °C
U-Link	no

Imperial measurements

The data shown are for information purposes only.

Control unit	PERSEO CBE
Power supply	230 V
Power consumption	300 W
Opening or closing time	7 s
Rod height	19.68505 inch
Rod diameter	4.5275615 inch
Type of limit switch	REED magnetic sensor
Slowdown	Yes

Impact resistance	6000 J
Break-in proof	60000 J
Manual cycle	reversible in the absence of voltage
Frequency of use	Semi intensive
Protection rating	IP67
Environmental conditions	-4 ÷ 140 °F
U-Link	no